• The Rust Bullet Application Guidelines contain complete detailed clean-up information. Application equipment must be cleaned immediately after use to avoid damage. Spills must be cleaned up immediately with Rust Bullet Solvent or the product will harden and become next to impossible to remove.
• Avoid getting paint on your body, clothes, or any surface not intended to be coated. Rust Bullet coatings are permanent; after curing, Rust Bullet can only be removed with rigorous abrasive action. Clean up fresh, uncured Rust Bullet immediately by using Rust Bullet Solvent, following the directions on the label. Washing with soap and water may work, if done immediately.
• Use Rust Bullet Solvent for Cleanup. Do not make assumptions about other cleanup solvents without consulting Rust Bullet Customer Support. Even a very small contamination of Rust Bullet with alcohol or other hydroxyl-containing solvents can destroy the moisture-cure reaction partly or entirely without any indication or jelling.
• Spills must be cleaned up with Rust Bullet Solvent immediately or the product will harden and become next to impossible to remove.
• Application equipment must be cleaned with Rust Bullet Solvent immediately after use to avoid damage. Thoroughly flush equipment with Rust Bullet Solvent. Do not leave residue as it will harden and become insoluble in solvent. Clean equipment as you would with any typical two component catalyzed coating. Always clean brush or roller thoroughly. Dunking dirty equipment in Rust Bullet Solvent will not prevent the coating from curing overnight. While not recommended, if you want to clean your brush, you will need to soak, dab, massage, scrub, comb, and wipe as appropriate, to dissolve, clean, and thoroughly remove the coating. This can require numerous soaks with clean solvent for each soak and should be repeated until the solvent used to clean remains clean and clear, indicating the coating has been completely removed. We recommend that you consider using less expensive brushes and rollers that can be discarded after use rather than cleaned.
• NOTE: If Rust Bullet Solvent is unavailable, Xylene, Toluene or MEK may be substituted.