Product Preparation – Stirring &Mixing

• Do not open Rust Bullet coatings until ready to use to maintain product shelf life.
• Do not open and stir a Rust Bullet coating when the temperature is below the dew point.
• Rust Bullet coatings should be stirred thoroughly for at least three minutes or until completely uniform and homogenous (avoid whipping air into product). Shaking the container prior to application may cause the formation of bubbles in the finish of the coating. Never stir the product by mechanical means; this will trap air molecules containing moisture between the coating and the surface causing improper curing and possible coating failure.
• Rust Bullet products that have been sitting for six months or longer may develop settling. Follow the same stirring instructions but increase the stir time and be sure to break up any clumps on the bottom of the container, if any.
• Pour out what you intend to use in one hour and immediately wipe clean the rim of your container and reseal to preserve coating.
• Never pour any unused coating back into the container as it will contaminate the entire can.